Skip to content

Subtractive Workflow

Sander van Rossen edited this page Nov 19, 2026 · 4 revisions

Instead of building rooms out of walls, you can start from solid space and carve the level out of it, the way many classic level editors work. There are two ways to do this.

Carving rooms out of a solid

In any model: a large additive brush is the rock, and subtractive brushes below it are the rooms and corridors.

  • Each subtractive brush or generator cuts away everything inside it, and its faces become the walls, floor and ceiling of the space it carves out.
  • Rooms that overlap or touch simply join.
  • The carving is non destructive: you can move, resize or remove a room at any time.

The Subtractive Workflow setting

Turn on Subtractive Workflow in a model's settings and the model is solid everywhere, without a rock brush: its brushes are the empty space, drawn from inside.

  • An additive brush or generator is a room. Rooms that overlap or touch join.
  • A subtractive brush inside a room is solid again: a pillar, a ledge, a block.
  • Drawing a shape on a room's surface follows this: pulled out of the surface it becomes a pillar, pushed into it a pit or an alcove. The same goes for a shape drawn on a surface and extruded into a brush.
  • Textures, hotspot tiles and decals read the right way round from inside the room, not mirrored. A texture mirrored on purpose with its uv scale stays mirrored.
  • You collide with the walls, floor and ceiling from inside the room. Leave Convex off in the collider settings: a convex collider fills the rooms.
  • It is meant for indoor levels: light rooms with lights inside them. The rooms have no outside, so a sun outside them is not shadowed by their walls or ceilings.
  • Lightmaps and light probes bake as in any other model, and bake again after a room is changed.

Turning the setting on or off rebuilds the model. The rooms and the brushes stay as they are; only which side they are drawn from changes.

See also Operations.

Clone this wiki locally